DIE FORGING
Key drivers KERA 100, 200 und 400
Banning® produces pneumatic key drivers to blow in and out the fastening wedges on forging dies of hammers and screw presses. The key driver is usually mounted on the forks of a forklift or on a crane with a special handling device. The mode of operation is pneumatic. By activating the two-hand control a blow is triggered. The piston rod drives the impact head forward at high speed. The impact strength can be regulated in several steps, so that the intensity of the impacts can be controlled quite precisely.General technical data
PARAMETERS
KERA 100
KERA 200
KERA 400
Blow energy at max.
stroke and working
pressure of 6 bar
1 kNm
2 kNm
4 kNm
Piston stroke max.
400 mm
500 mm
600 mm
Control cable between
two-hand and ram
2000 mm
2000 mm
2500 mm
Weight with
crane suspension
860 kg
1560 kg
2860 kg
Compressed air supply
¾"
¾"
¾"
Working pressure
6 - 8 bar
6 - 8 bar
6 - 8 bar
TYPE
max. wedge dimensions
KERA 100
60 x 80 x 500 mm
KERA 200
80 x 120 x 1000 mm
KERA 400
100 x 200 x 2000 mm
General technical data
DIE FORGING
KEY DRIVERS KERA 100, 200 und 400
Banning® produces pneumatic key drivers to blow in and out the fastening wedges on forging dies of hammers and screw presses. The key driver is usually mounted on the forks of a forklift or on a crane with a special handling device. The mode of operation is pneumatic. By activating the two-hand control a blow is triggered. The piston rod drives the impact head forward at high speed. The impact strength can be regulated in several steps, so that the intensity of the impacts can be controlled quite precisely.
